Page 1 of 1
Nikon Microphot stepper adapter
Posted: Fri Feb 07, 2020 7:34 pm
by Saul
Nikon Microphot stepper adapter
STL file:
https://www.thingiverse.com/thing:4149920
Re: Nikon Microphot stepper adapter
Posted: Fri Feb 07, 2020 10:27 pm
by PeteM
Nicely done, Saul. Looks like you're revolutionizing things, one STL file at a time.
Re: Nikon Microphot stepper adapter
Posted: Fri Feb 07, 2020 10:42 pm
by Saul
PeteM wrote: ↑Fri Feb 07, 2020 10:27 pm
Nicely done, Saul. Looks like you're revolutionizing things, one STL file at a time.
Thanks, Pete !
Re: Nikon Microphot stepper adapter
Posted: Mon Feb 10, 2020 9:17 pm
by microb
Hi Saul,
What workflow are you using with such a set up? As in, do you zero at the lowest level and then motor away while video-ing, then use toupview to z-focus the resulting movie file?
I'm curious what people out there use for software/controllers and how they prevent crashing the objective.
Thanks,
Ted
Re: Nikon Microphot stepper adapter
Posted: Mon Feb 10, 2020 9:43 pm
by Saul
microb wrote: ↑Mon Feb 10, 2020 9:17 pm
...What workflow are you using with such a set up? As in, do you zero at the lowest level and then motor away while video-ing, then use toupview to z-focus the resulting movie file?
I'm curious what people out there use for software/controllers and how they prevent crashing the objective...
Hi Ted !
I'm using WeMacro controller. Yes, focus at the lowest point (little bit more, in order to catch lowest focus point), setting as a start point in the controller, next - to the highest point (setting end point in the controller), step size is already preset, taking bunch of photos (not a video), next - stacking in Zerene or Photoshop. Same story with my DIY
vertical or
horizontal setups.