LED for Nikon Labophot Dual View (Teaching) head
Posted: Wed Mar 25, 2020 7:32 am
Here my upgrade for a Nikon Labophot Dual View (Teaching) head
The original lamp for the arrow pointer was missing so I made a LED lamp myself.
Anyone who can work with a lathe can make it
Here a few building tips
Start with an aluminum cylinder from 18 mm length and a diameter from 17 mm.
Drill a 11.0 mm hole and then a thread from M12 x1.5
Make 2 grooves for O-rings. Check whether the size is correct for proper clamping
Place a piece of acrylic round at the front, diameter 17 mm and 3 mm thick.
Place a PG7 cord strain relief . And adhesive on the acrylic round at the top.
As a lamp I used IKEA USB lamp of 5V 0.3 Watt
The original lamp for the arrow pointer was missing so I made a LED lamp myself.
Anyone who can work with a lathe can make it
Here a few building tips
Start with an aluminum cylinder from 18 mm length and a diameter from 17 mm.
Drill a 11.0 mm hole and then a thread from M12 x1.5
Make 2 grooves for O-rings. Check whether the size is correct for proper clamping
Place a piece of acrylic round at the front, diameter 17 mm and 3 mm thick.
Place a PG7 cord strain relief . And adhesive on the acrylic round at the top.
As a lamp I used IKEA USB lamp of 5V 0.3 Watt