Page 1 of 1
BH2 UMA to MTV3 Adapter
Posted: Sun May 19, 2019 2:12 am
by microb
Doing a tube lens set up for a BHM microscope. So using the tube lens un the UMA epi, and instead of a triocular setup, the following modeled tube hooks up to a MTV-3 adapter that has a lens to aim light for the C-mount camera.
Re: BH2 UMA to MTV3 Adapter
Posted: Mon May 27, 2019 12:21 am
by microb
Here is the 3D print with and without the relay lens, along side the triocular head it matches:
Re: BH2 UMA to MTV3 Adapter
Posted: Mon May 27, 2019 4:55 am
by Scarodactyl
That is awesome!
Re: BH2 UMA to MTV3 Adapter
Posted: Mon May 27, 2019 6:02 pm
by Crater Eddie
Way cool! How long did it take to print? We 3D print some prototyping parts at work, takes a while some times, but very well worth the effort.
CE
Re: BH2 UMA to MTV3 Adapter
Posted: Mon May 27, 2019 7:02 pm
by microb
This is a PLA print of 7 hours.
Re: BH2 UMA to MTV3 Adapter
Posted: Mon May 27, 2019 7:55 pm
by tgss
Nice work microb. Very well done.
Tom
Re: BH2 UMA to MTV3 Adapter
Posted: Sun Jun 30, 2019 11:32 pm
by SunshineLW
Totally badass! Going hard with that 3d printer!