Page 1 of 1
Permanent slides from Formalin-preserved samples
Posted: Thu Apr 20, 2023 4:50 pm
by Sure Squintsalot
I have samples of micro stuff fixed preserved in 10% formalin solution and want to make permanent slides mounted in standard tissue-mountant.
Do I let the formalin dry out from the sample while on a slide?
Or must the formalin be rinsed out completely in some rinsing protocol?
Re: Permanent slides from Formalin-preserved samples
Posted: Thu Apr 20, 2023 6:39 pm
by Alexander
Sure Squintsalot wrote: ↑Thu Apr 20, 2023 4:50 pm
Or must the formalin be rinsed out completely in some rinsing protocol?
That!
Hang the sample into ethanol 70 %. The formalin is heavier and goes to the ground. Change the ethanol after some hour. Then follow the mounting procedure for your mounting media.
Re: Permanent slides from Formalin-preserved samples
Posted: Thu Apr 20, 2023 8:35 pm
by Sure Squintsalot
...I understand.
However, I'm mounting unconsolidated micro-materials (think plankton-like) and not a large tissue sample. If the formalin settles to the bottom of my vessel, it will mix with the materials that have collected there. I'd then need a way to separate the settled formaldehyde. But I see the value in this process for large samples that can be suspended.
If I could float the formaldehyde above my sample, I'd have an easy way to draw it off quickly and easily.
I'll try successive rinses in pure water; before moving on to yet another organic solvent that I don't have!