Rotating stage for Laborlux S
Posted: Sun Aug 15, 2021 12:45 pm
Hi guys
Been imaging crystals lately and they are not always in the right postion on the slide so came up with this for my Laborlux S scope. Attaches to the x axis slider. Trying it both with the conveyor bearings and without, prefer without I think.
Its turned gently by thumb and the slide pushed or pulled in the top slot. Seems to work ok, designed in DesignSpark Mechanical - an excellent free cad package.
Steve
Been imaging crystals lately and they are not always in the right postion on the slide so came up with this for my Laborlux S scope. Attaches to the x axis slider. Trying it both with the conveyor bearings and without, prefer without I think.
Its turned gently by thumb and the slide pushed or pulled in the top slot. Seems to work ok, designed in DesignSpark Mechanical - an excellent free cad package.
- stage1.jpg (29.48 KiB) Viewed 4742 times
- stage2.jpg (28.96 KiB) Viewed 4742 times
- stage3.jpg (27.65 KiB) Viewed 4742 times
Steve
, I think these 3d printers are becoming very useful for a lot of hobbies !.