Slider 3D

Here you can discuss DIY adaptations to the microscope.
Post Reply
Message
Author
Sabatini
Posts: 464
Joined: Tue Nov 12, 2019 3:09 am

Slider 3D

#1 Post by Sabatini » Tue Jun 14, 2022 4:17 pm

Good morning forum friends.
I am trying to 3D print the slider microscope condenser for laborlux s but modifying the phase ring for a Phaco 40x objective.
Can someone help me with the design or provide me the link to find the post referencing this design that someone posted earlier here .
Any suggestions?
Thanks.
IMG_20220614_111544.jpg
IMG_20220614_111544.jpg (88.55 KiB) Viewed 1895 times
IMG_20220614_111229.jpg
IMG_20220614_111229.jpg (67.01 KiB) Viewed 1895 times

BramHuntingNematodes
Posts: 1538
Joined: Tue Jan 21, 2020 1:29 am
Location: Georgia, USA

Re: Slider 3D

#2 Post by BramHuntingNematodes » Tue Jun 14, 2022 4:25 pm

If you have a phase telescope and some vernier calipers you can directly measure the diameter of the ring that way.
1942 Bausch and Lomb Series T Dynoptic, Custom Illumination

Sabatini
Posts: 464
Joined: Tue Nov 12, 2019 3:09 am

Re: Slider 3D

#3 Post by Sabatini » Tue Jun 14, 2022 8:05 pm

Thank you

Sabatini
Posts: 464
Joined: Tue Nov 12, 2019 3:09 am

Re: Slider 3D

#4 Post by Sabatini » Sat Jun 18, 2022 4:42 pm


Sabatini
Posts: 464
Joined: Tue Nov 12, 2019 3:09 am

Re: Slider 3D

#5 Post by Sabatini » Wed Jul 06, 2022 2:07 am

Is working great!!!.
Thanks to matthieusrb.
PXL_20220706_020300091 (3).jpg
PXL_20220706_020300091 (3).jpg (126.69 KiB) Viewed 1607 times

Post Reply