We bought a Amscope B120B on Amazon and it arrived already put together. I'm not sure if it was a return. I was seeing a lot of debris or something that is present at all magnification levels. After cleaning the eyepiece, objectives, light source and camera lenses, it looks a lot better except the two white spots are still there. Is this normal? Should the background be greenish?
Here is a screen shot at each magnification taken with the MU300.
Is this normal?
-
- Posts: 7
- Joined: Sun Dec 28, 2014 4:42 am
Is this normal?
- Attachments
-
- 100x no slide.jpeg (39.25 KiB) Viewed 4491 times
-
- 40x no slide.jpeg (36.29 KiB) Viewed 4491 times
-
- 10x no slide.jpeg (26.55 KiB) Viewed 4491 times
-
- 4x no slide.jpeg (27.47 KiB) Viewed 4491 times
Re: Is this normal?
Hello,
A microscope that is put together is normal.
the white spots appear to be reflections of some light. i assume that the camera takes the placeof one of the eyepieces. cover the second eyepiece, it could be that light entering the second eyepiece causes these reflections. the reflections stay the same regardless of magnification, and therefore I think that this might be a reflection of your room light entering the system somehow.
also raise and lower the condensor and see what happens.
Locate the source of the debris. is it on the camera? rotate the camera, if the dust stays on the same spot, then the dust is on the sensor. if the dust also rotates, then it is on sme other component. for a new microscope, there does seems to be much dust.
The green color is a question of white balance.
Oliver
A microscope that is put together is normal.
the white spots appear to be reflections of some light. i assume that the camera takes the placeof one of the eyepieces. cover the second eyepiece, it could be that light entering the second eyepiece causes these reflections. the reflections stay the same regardless of magnification, and therefore I think that this might be a reflection of your room light entering the system somehow.
also raise and lower the condensor and see what happens.
Locate the source of the debris. is it on the camera? rotate the camera, if the dust stays on the same spot, then the dust is on the sensor. if the dust also rotates, then it is on sme other component. for a new microscope, there does seems to be much dust.
The green color is a question of white balance.
Oliver
Oliver Kim - http://www.microbehunter.com - Microscopes: Olympus CH40 - Olympus CH-A - Breukhoven BMS student microscope - Euromex stereo - uSCOPE MXII
Re: Is this normal?
I agree with Oliver. If I were you I would have them replace it. It may well be a return.Oliver wrote: for a new microscope, there does seems to be much dust.
-
- Posts: 7
- Joined: Sun Dec 28, 2014 4:42 am
Re: Is this normal?
You are right about the white spots. When I cover the eyepiece, it goes away.
Rotating the camera, also rotates the dust, so it's not on the sensor.
Rotating the camera, also rotates the dust, so it's not on the sensor.
Re: Is this normal?
Hmm - if the 'dust' rotates when you rotate the camera then it will be on the sensor or any lenses (e.g. reduction)justcurious wrote:You are right about the white spots. When I cover the eyepiece, it goes away.
Rotating the camera, also rotates the dust, so it's not on the sensor.
that attach with the camera onto or into the eyepiece. I used to get this problem constantly and think it was simply
from removing an eyepiece for my Toupcam that kept allowing in dust etc. I finally bought a 'scope with a dedicated
phototube.
JB
John B