Page 1 of 1
Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 6:28 pm
by Sabatini
I am fixing the leitz laboelux s focusing mechanism but the pellets are cylindrical and now I didn't check well if they go lying down or slanting.
What is the correct way to put them please ?
Thanks
- Screenshot_2023-03-12-13-28-08-788-edit_com.whatsapp.jpg (42.66 KiB) Viewed 1426 times
Re: Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 7:05 pm
by PeteM
They are usually "standing" and crisscrossed to provide lateral stability while still rolling.
Re: Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 7:33 pm
by Sabatini
PeteM wrote: ↑Sun Mar 12, 2023 7:05 pm
They are usually "standing" and crisscrossed to provide lateral stability while still rolling.
I get it now... thanks PeteM.
Re: Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 7:38 pm
by Sabatini
...But now thinking about it a little more carefully, are they all on the same side or are they crossed, one to the right and the other to the left, interspersed?
Re: Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 8:21 pm
by PeteM
Crossed. Do you also have a spacer to separate groups crossed rollers?
Re: Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 8:56 pm
by Sabatini
- Screenshot_2023-03-12-15-52-26-398-edit_com.appsuite.photo.compressor.reduce.size.jpg (55.56 KiB) Viewed 1386 times
PeteM wrote: ↑Sun Mar 12, 2023 8:21 pm
Crossed. Do you also have a spacer to separate groups crossed rollers?
Re: Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 9:11 pm
by PeteM
That's it. A bit of grease can help hold them in place for reassembly.
Re: Leitz Laborlux s need help
Posted: Sun Mar 12, 2023 10:29 pm
by Sabatini
PeterM , Thank you very much for your valuable collaboration. I had a really good time!!!